Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Andy Peters
11/10/06 14:55
Read: 608 times
Tucson, Az
USA


 
Msg Score: 0
 +1 Good Answer/Helpful
 -1 Overrated
#127748 - the Shield
Responding to: Ap Charles's previous message
Ah, a good violent TV show about corrupt cops in the inner city.

but I digress.

Balanced signalling? Connect the shield TO THE CHASSIS/ENCLOSURE at both ends. Connect the chassis to the circuit ground at one point (usually the power-entry).

-a

List of 20 messages in thread
TopicAuthorDate
Lightning protection      Ap Charles      11/08/06 06:17      
   there is much to this      Erik Malund      11/08/06 06:19      
      Lightning protection      Ap Charles      11/08/06 06:24      
         so doesa EMI      Erik Malund      11/08/06 06:36      
            Mr. Faraday knew how...      Kai Klaas      11/08/06 08:13      
               THICK metal      Steve M. Taylor      11/08/06 09:45      
            Direct Hits      Russell Bull      11/08/06 17:06      
               Keep it out of the encosure!      Kai Klaas      11/08/06 20:08      
                  My pplication      Ap Charles      11/08/06 23:52      
                     Details?      Kai Klaas      11/11/06 08:33      
               I disagree      Erik Malund      11/09/06 06:07      
                  No, no...      Kai Klaas      11/09/06 20:32      
                     Disconnecting the shield at one end of the cables      Ap Charles      11/09/06 23:44      
                        a) and b)      Erik Malund      11/10/06 06:05      
                           Yes, crossed opinions...      Kai Klaas      11/10/06 09:18      
                              and the twain shall never meet      Erik Malund      11/10/06 10:52      
                        the Shield      Andy Peters      11/10/06 14:55      
                           The RS485 signal lines is galvanically...........      Ap Charles      11/10/06 23:01      
                              GND of RS485 bus, PROFIBUS      Kai Klaas      11/11/06 08:27      
   If you get this close        Jez Smith      11/09/06 01:28      

Back to Subject List