Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Richard Erlacher
02/26/09 10:15
Read: 685 times
Denver, Co
USA


 
#162900 - Well, I just guessed ...
Responding to: Joseph Hebert's previous message
I told him I thought there was a problem with bit penetration and feed rate, and with dull tools, where the smearing is concerned. I'd assume the machine/software knows enough about its bits to know how to accommodate the various tools it uses.

Since I first discussed this matter with him, he's limited his use of the LPKF machine to drilling. Apparently that works for him.

RE


List of 25 messages in thread
TopicAuthorDate
PCB prototype        Joseph Hebert      02/25/09 11:23      
   How does the LPKF machine do as a drill?      Richard Erlacher      02/25/09 16:09      
      tool life      Joseph Hebert      02/25/09 20:33      
         Well, I just guessed ...      Richard Erlacher      02/26/09 10:15      
            Expensive Drill      Joseph Hebert      02/26/09 10:30      
               Indeed! But useless for anything else.      Richard Erlacher      02/26/09 16:10      
                  Expensive? Yes. Useless? ...      Joseph Hebert      02/27/09 09:49      
                     True enough!      Richard Erlacher      02/27/09 10:00      
                        Dull Tools      Joseph Hebert      02/27/09 14:07      
                           dull tools      Richard Erlacher      02/27/09 14:29      
                              10 mil end mills      Joseph Hebert      02/27/09 14:53      
                                 Wet ?      Steve M. Taylor      03/01/09 15:34      
                                    Air cooled only      Joseph Hebert      03/01/09 15:57      
   Plating??      Chris Bertrand      02/25/09 20:54      
      plating      Joseph Hebert      02/26/09 07:42      
         I figured as such      Chris Bertrand      02/26/09 07:48      
   very good quality      JecksonS Ben      02/26/09 00:19      
   Impressive but..      Oliver Sedlacek      02/26/09 01:32      
      Prototyping prices      Joseph Hebert      02/26/09 08:07      
         Very interesting approach      Dave Brooks      02/28/09 13:43      
            PCBExpress      Joseph Hebert      02/28/09 21:41      
               Sunstone Circuits      Michael Karas      02/28/09 23:56      
                  Sunstone      Joseph Hebert      03/01/09 16:16      
                  P.S. Welcome back      Joseph Hebert      03/02/09 09:39      
               Now-a-days...      Dave Brooks      03/02/09 13:41      

Back to Subject List