Try to run the initialize target command...

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread

Kai Klaas 01/11/12 17:13 Read: 159 times Germany	#185440 - Try to run the initialize target command... Responding to: ???'s previous message
	...before entering the run mode. Kai Klaas

List of 7 messages in thread

Topic Author Date
AT89ISP Reset Pin Issue       Jon Wilder       01/11/12 12:02
   If you want a positive-going RESET ...       Richard Erlacher       01/11/12 13:10
      no, you can't         Erik Malund       01/11/12 13:21
         You can do it, though you may not want to       Richard Erlacher       01/11/12 23:35
   The AT89ISP will expect active-high RESET       David Prentice       01/11/12 13:11
   Try to run the initialize target command...       Kai Klaas       01/11/12 17:13
      By the way...       Kai Klaas       01/12/12 07:57

Back to Subject List

Topic	Author	Date
AT89ISP Reset Pin Issue	Jon Wilder	01/11/12 12:02
If you want a positive-going RESET ...	Richard Erlacher	01/11/12 13:10
no, you can't	Erik Malund	01/11/12 13:21
You can do it, though you may not want to	Richard Erlacher	01/11/12 23:35
The AT89ISP will expect active-high RESET	David Prentice	01/11/12 13:11
*Try to run the initialize target command...*	Kai Klaas	01/11/12 17:13
By the way...	Kai Klaas	01/12/12 07:57