Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Maarten Brock
02/22/12 07:01
Read: 510 times
Tilburg
The Netherlands


 
#186136 - Uart stall
Responding to: Michael Karas's previous message
When you hit a breakpoint on a SiLabs device the SYSCLK is stopped and thus the UART is stopped as well. You can no longer transmit correct data and you cannot receive anything either.

List of 17 messages in thread
TopicAuthorDate
Help. Writing Hex code from serial port to External device      Dave McNamara      01/27/12 15:42      
   Look at this      Michael Karas      01/27/12 18:46      
      Using 8051      Dave McNamara      01/28/12 03:19      
   Why ASM?      Andy Neil      01/30/12 14:43      
      Design your subroutine(s)      David Prentice      01/30/12 15:20      
   RI Flag      Dave McNamara      02/20/12 08:48      
      READ_SERIAL      Michael Karas      02/20/12 09:25      
         RI setup      Dave McNamara      02/20/12 09:57      
            are you sure?      Erik Malund      02/20/12 10:04      
               CKCON      Dave McNamara      02/20/12 10:22      
                  well, then      Erik Malund      02/20/12 11:17      
                     Correct      Dave McNamara      02/20/12 12:11      
                        RI and TI      Erik Malund      02/20/12 12:24      
                           Ok      Dave McNamara      02/20/12 12:32      
                              Diff Of TI and RI      Michael Karas      02/20/12 12:57      
                                 Uart stall      Maarten Brock      02/22/12 07:01      
                        Oscilloscope      Per Westermark      02/20/12 17:04      

Back to Subject List