Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Jim Granville
02/28/12 23:39
Read: 524 times


 
#186271 - Isolated Switch
Responding to: Chico Magalh„es's previous message
The AC side caps look redundant, and the DC side can reduce to one.
An inrush power resistor is a good idea, some SMPS use a NTC for inrush limiting.

You _will_ need some isolation, and a perspex or similar cover for the leds, to make it somewhat safer.

If you do not strobe fast, then a device like PVI5080 will turn a Logic Level power FET, into a solid state relay.
An Opto-Scr might also work, looks like current would fall below a SCR holding current.

List of 27 messages in thread
TopicAuthorDate
AC Powered LEDs + strobe      Chico Magalh„es      02/28/12 22:58      
   Isolated Switch      Jim Granville      02/28/12 23:39      
      Switching      Chico Magalh„es      03/15/12 00:41      
   Some basics      Oliver Sedlacek      02/29/12 00:54      
      Not a good design - and expensive        Per Westermark      02/29/12 03:00      
         Answers + need some explantion      Chico Magalh„es      02/29/12 23:55      
      Cap voltage      Chico Magalh„es      03/01/12 00:03      
         More than 280V      Oliver Sedlacek      03/02/12 04:30      
            Measurement      Chico Magalh„es      03/15/12 00:45      
               Measurement correct      Erik Malund      03/15/12 07:54      
   two caps polarity reversed on DC!! ?      Erik Malund      02/29/12 07:13      
      More common long time ago      Per Westermark      02/29/12 08:33      
         I was around then      Erik Malund      02/29/12 09:21      
            Some polarized capacitors survives AC but not reversed DC      Per Westermark      02/29/12 10:01      
               POOOOOOOOOF      Erik Malund      02/29/12 10:27      
                  Yes, very likely a failure      Per Westermark      02/29/12 11:10      
                     that need bold face      Erik Malund      02/29/12 11:44      
            Back to back connection...      Kai Klaas      03/02/12 17:05      
   And another thing...      Andy Neil      02/29/12 15:30      
      Pseudo-CC with resistor requires much % V over resistor      Per Westermark      02/29/12 16:52      
      chip      Chico Magalh„es      03/01/12 00:11      
         one of these      Erik Malund      03/01/12 08:00      
         Chips      Andy Neil      03/01/12 14:33      
   PC PSU      Chico Magalh„es      03/15/12 00:47      
      Definitely better with lower voltage design      Per Westermark      03/15/12 01:11      
         PSU      Chico Magalh„es      03/15/12 18:37      
            Some bricks can inform about rating      Per Westermark      03/16/12 02:21      

Back to Subject List