Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Oliver Sedlacek
03/02/12 04:30
Read: 476 times
Uk


 
#186351 - More than 280V
Responding to: Chico Magalh„es's previous message
Tha reservoir capacitor voltage may only be 280V when the LEDs are lit, but when you turn them off it will rise to peak rectified mains, i.e. 375V.

Fuses may be medieval, but they reliably protect systems from over current faults. They are well understood, which is why they are mandatory in critical systems. They do however have large tolerances and operate slowly, making them completely useless for protecting LEDs.

List of 27 messages in thread
TopicAuthorDate
AC Powered LEDs + strobe      Chico Magalh„es      02/28/12 22:58      
   Isolated Switch      Jim Granville      02/28/12 23:39      
      Switching      Chico Magalh„es      03/15/12 00:41      
   Some basics      Oliver Sedlacek      02/29/12 00:54      
      Not a good design - and expensive        Per Westermark      02/29/12 03:00      
         Answers + need some explantion      Chico Magalh„es      02/29/12 23:55      
      Cap voltage      Chico Magalh„es      03/01/12 00:03      
         More than 280V      Oliver Sedlacek      03/02/12 04:30      
            Measurement      Chico Magalh„es      03/15/12 00:45      
               Measurement correct      Erik Malund      03/15/12 07:54      
   two caps polarity reversed on DC!! ?      Erik Malund      02/29/12 07:13      
      More common long time ago      Per Westermark      02/29/12 08:33      
         I was around then      Erik Malund      02/29/12 09:21      
            Some polarized capacitors survives AC but not reversed DC      Per Westermark      02/29/12 10:01      
               POOOOOOOOOF      Erik Malund      02/29/12 10:27      
                  Yes, very likely a failure      Per Westermark      02/29/12 11:10      
                     that need bold face      Erik Malund      02/29/12 11:44      
            Back to back connection...      Kai Klaas      03/02/12 17:05      
   And another thing...      Andy Neil      02/29/12 15:30      
      Pseudo-CC with resistor requires much % V over resistor      Per Westermark      02/29/12 16:52      
      chip      Chico Magalh„es      03/01/12 00:11      
         one of these      Erik Malund      03/01/12 08:00      
         Chips      Andy Neil      03/01/12 14:33      
   PC PSU      Chico Magalh„es      03/15/12 00:47      
      Definitely better with lower voltage design      Per Westermark      03/15/12 01:11      
         PSU      Chico Magalh„es      03/15/12 18:37      
            Some bricks can inform about rating      Per Westermark      03/16/12 02:21      

Back to Subject List