Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Per Westermark
03/09/12 15:10
Read: 576 times
Sweden


 
#186544 - Isn't boot time always time from reset or time from power-on
Responding to: ???'s previous message
It says in the appendix "Boot-up time means the total time consumed by FIM5360 after
system power up and /Reset are supplied"

So would that mean that it takes .7 seconds after its plugged in or 0.7 seconds after
I send my first command to it?


Don't you think the appendix text is rather clear about this? They mention "power up" and "/reset" - does not sound like timing started from you send any commands but from you turn on power or release the physical reset line.

List of 17 messages in thread
TopicAuthorDate
Serial coms, bytes not matching in serial capture      Dave McNamara      03/07/12 10:22      
   Couple of things at first glance...      Robert Revens      03/07/12 12:52      
      Response      Dave McNamara      03/07/12 13:13      
         OK      Robert Revens      03/07/12 14:09      
   what does the instruction spell out      Erik Malund      03/07/12 13:46      
      Instruction says      Dave McNamara      03/07/12 14:17      
         Got it      Dave McNamara      03/07/12 14:29      
            have a good read      Erik Malund      03/08/12 07:16      
               Nitgen FIM5360 module      Dave McNamara      03/09/12 11:46      
                  Not familiar with the module...      Robert Revens      03/09/12 14:03      
                     Boot up time...      Robert Revens      03/09/12 14:15      
                     Response      Dave McNamara      03/09/12 14:55      
                        Isn't boot time always time from reset or time from power-on      Per Westermark      03/09/12 15:10      
                           Ok      Dave McNamara      03/09/12 15:18      
                        SCON1...      Robert Revens      03/10/12 05:24      
                           Jumping from RET to Jump Start      Dave McNamara      03/10/12 07:43      
   Please Ignore last post, issue resolved      Dave McNamara      03/10/12 10:30      

Back to Subject List