Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Erik Malund
03/23/12 06:57
Read: 531 times
Mt Airy, Nc
USA


 
#186829 - where did you get that idea?
Responding to: ???'s previous message
The wait LCD label is redundant,better off using a delay routine
where did you get that idea?
checking the LCD ready bit is, by far, the most reliable and fastest method.
that some posting amateurs have not figured that out is no reason for you to follow the herd.

Erik

List of 13 messages in thread
TopicAuthorDate
4 Bit LCD      Sean O Mara      03/22/12 12:10      
   I am no sherlock Holmes, but ...      Erik Malund      03/22/12 13:31      
      LCD      Sean O Mara      03/22/12 13:56      
         Did you think about accesses using DATA1?      Per Westermark      03/22/12 15:41      
            lcd      Sean O Mara      03/22/12 17:18      
               So you found a solution ...      Andy Neil      03/22/12 18:02      
                  LCD 4 BIT      Sean O Mara      03/23/12 06:49      
                     where did you get that idea?      Erik Malund      03/23/12 06:57      
                        Using Read Cycle to LCD      Michael Karas      03/23/12 10:33      
                           of course, you can not use a signal that is not there      Erik Malund      03/23/12 10:45      
                        busy flad check      Sean O Mara      03/23/12 16:02      
                           Why not solve your problem BEFORE trying to save pins?        Richard Erlacher      03/24/12 08:16      
                              Premature optimisation      Andy Neil      03/24/12 09:48      

Back to Subject List