Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Erik Malund
03/28/12 13:48
Read: 567 times
Mt Airy, Nc
USA


 
#186936 - you can connect the encoder output
Responding to: ???'s previous message
the whole process from when the information leaves pin 6 on the encoder to the output of the decoder is a bit confusing.

you can connect the encoder output to the decoder input diretly, that would allow you to verify all except the RF

if you do not understand what is inbetween, I can't help you any, matched transmitter receiver pair will work

http://pdf1.alldatasheet.com/datasheet...-433R.html
does the manufacturer not have a website? there may be appnotes and more there. Getting data from a "datasheet collecting website" is a VERY bad idea and ONLY has merit for ancient parts where the manufacturer has deleted the datasheet from their website.

Erik


List of 4 messages in thread
TopicAuthorDate
encoder to decoder confusion      Daniel O Sullivan      03/28/12 08:15      
   you can connect the encoder output      Erik Malund      03/28/12 13:48      
      project      Daniel O Sullivan      03/28/12 14:22      
   Encoder circuit      Ramesh Rai      04/18/12 21:02      

Back to Subject List