Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
06/08/12 11:23
Read: 1244 times


 
#187636 - AUTOCUTTER
Hello sir,
I am working on autocutter for thermal printer. My autocutter part is working fine but the problem is that number of steps required for full cut and partial cut are 630 and 544 respectively. But to perform partial and full i required to give steps more than given steps which i have mentioned earlier steps. I am not getting idea that where i am going wrong. More than that i am confused that whether my code is missing something or autocutter has a mechanical problem. Please help me about that.
Thank you.

List of 11 messages in thread
TopicAuthorDate
AUTOCUTTER      Manoj Wakdikar      06/08/12 11:23      
   so am I, reading the above      Erik Malund      06/08/12 12:15      
   Missed steps?      Per Westermark      06/08/12 12:18      
      Autocutter      Manoj Wakdikar      06/11/12 10:41      
         Have you tried lower speeds?      Per Westermark      06/12/12 05:26      
            regarding autocutter      Manoj Wakdikar      06/17/12 06:48      
               Need more info      Hal Albach      06/17/12 09:16      
               Need more info      Hal Albach      06/17/12 09:16      
                  Slack? Power available from first tick?      Per Westermark      06/17/12 10:37      
                     change speed      Maarten Brock      06/17/12 16:29      
   ??? re motor & driver      Hal Albach      06/08/12 14:25      

Back to Subject List