Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Per Westermark
06/08/12 12:18
Read: 594 times
Sweden


 
#187638 - Missed steps?
Responding to: ???'s previous message
Is it driven by a stepper motor?

If you step it too fast - especially directly when you start it - a stepper motor can fail to produce enough torque to actually accelerate the hardware to the required speed. This results in some of the steps being lost.

List of 11 messages in thread
TopicAuthorDate
AUTOCUTTER      Manoj Wakdikar      06/08/12 11:23      
   so am I, reading the above      Erik Malund      06/08/12 12:15      
   Missed steps?      Per Westermark      06/08/12 12:18      
      Autocutter      Manoj Wakdikar      06/11/12 10:41      
         Have you tried lower speeds?      Per Westermark      06/12/12 05:26      
            regarding autocutter      Manoj Wakdikar      06/17/12 06:48      
               Need more info      Hal Albach      06/17/12 09:16      
               Need more info      Hal Albach      06/17/12 09:16      
                  Slack? Power available from first tick?      Per Westermark      06/17/12 10:37      
                     change speed      Maarten Brock      06/17/12 16:29      
   ??? re motor & driver      Hal Albach      06/08/12 14:25      

Back to Subject List