Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
06/11/12 10:41
Read: 576 times


 
#187665 - Autocutter
Responding to: Per Westermark's previous message
Yes. It is a stepper motor. For this i have to give start step initially to move the cutter in forward direction and upto certain steps i have to keep increasing the speed of the motor. Once i reached to a certain step then i have to move the cutter in forward direction with a constant speed. There are total 8steps to move forward and reverse the cutter. To move the motor in forward direction i will give the steps like step 1,2,3,4,5,6,7,8 and to move in reverse direction i will give the steps like step 8,7,6,5,4,3,2,1. Now to move the cutter in reverse direction i have to give stop step and pause step and then step 8,7,6,5,4,3,2,1 like this and finally stop the motor.

List of 11 messages in thread
TopicAuthorDate
AUTOCUTTER      Manoj Wakdikar      06/08/12 11:23      
   so am I, reading the above      Erik Malund      06/08/12 12:15      
   Missed steps?      Per Westermark      06/08/12 12:18      
      Autocutter      Manoj Wakdikar      06/11/12 10:41      
         Have you tried lower speeds?      Per Westermark      06/12/12 05:26      
            regarding autocutter      Manoj Wakdikar      06/17/12 06:48      
               Need more info      Hal Albach      06/17/12 09:16      
               Need more info      Hal Albach      06/17/12 09:16      
                  Slack? Power available from first tick?      Per Westermark      06/17/12 10:37      
                     change speed      Maarten Brock      06/17/12 16:29      
   ??? re motor & driver      Hal Albach      06/08/12 14:25      

Back to Subject List