Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Richard Erlacher
10/05/12 13:45
Read: 673 times
Denver, Co
USA


 
#188584 - You don't have to do that
Responding to: ???'s previous message
External memory interfaces to 805x's are, for the most part, quite generic.

It wouldn't be hard for you to provide a schematic that's similar but not identical to the circuit with which you're having problems. Just include enough of the circuitry to show the external memory interface and all the circuitry that might be causing your timing issues. Once we see that, someone's likely to recognize your problem from one he/she's had before. You don't have to compromise any trade secrets, not that it's likely to happen.

Without that, it's unlikely any progress will be made.

RE


List of 18 messages in thread
TopicAuthorDate
SRAM issues      Harry Leung      09/26/12 04:09      
   Setup and hold times?      Per Westermark      09/26/12 04:21      
      RAM issues      Harry Leung      09/26/12 06:13      
         Or narrow pulses ?      Jim Granville      09/26/12 19:46      
      Address setup time      Harry Leung      10/02/12 20:48      
   did you change the arbitration?      Erik Malund      09/26/12 07:18      
      Ram issues      Harry Leung      09/26/12 07:36      
   P0, P2 for memory only, or ...      Erik Malund      09/26/12 09:04      
      p0 and p2      Harry Leung      09/27/12 03:29      
         If you latch both P0 and P2, there will be stabile A15-A0      Richard Erlacher      09/27/12 11:24      
   Arbitration circuit      Oliver Sedlacek      09/26/12 10:08      
   It's a bit tricky synchronizing an 805x with 68k series      Richard Erlacher      09/26/12 15:51      
   you are using a latch, and not a flipflop, right?      Richard Erlacher      09/26/12 22:54      
      FF or latch      Harry Leung      09/27/12 03:30      
         It's a mistake I've seen a time or two ...       Richard Erlacher      09/27/12 11:19      
            time wasting      Stefan KAnev      09/27/12 13:24      
               no circuit diagram      Harry Leung      09/27/12 20:38      
                  You don't have to do that      Richard Erlacher      10/05/12 13:45      

Back to Subject List