Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/14/12 08:44
Read: 773 times


 
#188638 - Ok so,
Responding to: Michael Karas's previous message
That means that i won't be fortunate enough to get a part ? Not even something form another manufacturer ?

List of 27 messages in thread
TopicAuthorDate
About AD574A      Akhil Bose      10/08/12 09:16      
   suitable      Neil Kurzman      10/08/12 16:28      
   price/performance      Erik Malund      10/09/12 07:40      
      Expensive or old      Neil Kurzman      10/09/12 15:58      
         if it's not "obsolete" it probably should be      Richard Erlacher      10/09/12 23:26      
            It's not obsolete      Andy Neil      10/10/12 00:38      
               I wonder what's keeping it "alive"      Richard Erlacher      10/10/12 07:36      
                  It became an industry standard...      Kai Klaas      10/10/12 12:44      
                     LM358      Mahmood Elnasser      10/10/12 14:10      
                        Dated      Michael Karas      10/10/12 16:11      
   'Find Similar Parts'      Andy Neil      10/10/12 00:44      
      I did not find any matching IC      Akhil Bose      10/13/12 17:10      
         Be Happy        Michael Karas      10/14/12 08:26      
            Ok so,      Akhil Bose      10/14/12 08:44      
               No, that's not what it means!      Richard Erlacher      10/14/12 10:35      
         RE: None of them match the Pin structure      Andy Neil      10/15/12 09:36      
   Maxim?      Hal Albach      10/14/12 11:04      
      I might be just a bit concerned about the conversion rate      Richard Erlacher      10/14/12 12:09      
   if it is repair, who cares      Erik Malund      10/15/12 10:20      
      There are places where that's a week's pay      Richard Erlacher      10/16/12 07:53      
         sure ...      Erik Malund      10/16/12 08:59      
            What was the goal?      Neil Kurzman      10/16/12 10:35      
            just a minute ..      Richard Erlacher      10/17/12 11:28      
   Ok ... so here is what i would do      Akhil Bose      10/17/12 07:36      
      then why the worry about the pinout ?        Erik Malund      10/17/12 07:41      
         Thanks Guys      Akhil Bose      10/17/12 10:07      
            you probably should back away from the original      Richard Erlacher      10/17/12 11:31      

Back to Subject List