Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Andy Neil
10/15/12 09:36
Read: 721 times
Basingstoke
Uk


 
#188644 - RE: None of them match the Pin structure
Responding to: ???'s previous message
Akhil Bose said:
I am looking for something which can replace the 574 without changes in the circuit board.

Could you make an "adaptor board" to allow some other chip to fit into the existing site on your existing PCB...?

List of 27 messages in thread
TopicAuthorDate
About AD574A      Akhil Bose      10/08/12 09:16      
   suitable      Neil Kurzman      10/08/12 16:28      
   price/performance      Erik Malund      10/09/12 07:40      
      Expensive or old      Neil Kurzman      10/09/12 15:58      
         if it's not "obsolete" it probably should be      Richard Erlacher      10/09/12 23:26      
            It's not obsolete      Andy Neil      10/10/12 00:38      
               I wonder what's keeping it "alive"      Richard Erlacher      10/10/12 07:36      
                  It became an industry standard...      Kai Klaas      10/10/12 12:44      
                     LM358      Mahmood Elnasser      10/10/12 14:10      
                        Dated      Michael Karas      10/10/12 16:11      
   'Find Similar Parts'      Andy Neil      10/10/12 00:44      
      I did not find any matching IC      Akhil Bose      10/13/12 17:10      
         Be Happy        Michael Karas      10/14/12 08:26      
            Ok so,      Akhil Bose      10/14/12 08:44      
               No, that's not what it means!      Richard Erlacher      10/14/12 10:35      
         RE: None of them match the Pin structure      Andy Neil      10/15/12 09:36      
   Maxim?      Hal Albach      10/14/12 11:04      
      I might be just a bit concerned about the conversion rate      Richard Erlacher      10/14/12 12:09      
   if it is repair, who cares      Erik Malund      10/15/12 10:20      
      There are places where that's a week's pay      Richard Erlacher      10/16/12 07:53      
         sure ...      Erik Malund      10/16/12 08:59      
            What was the goal?      Neil Kurzman      10/16/12 10:35      
            just a minute ..      Richard Erlacher      10/17/12 11:28      
   Ok ... so here is what i would do      Akhil Bose      10/17/12 07:36      
      then why the worry about the pinout ?        Erik Malund      10/17/12 07:41      
         Thanks Guys      Akhil Bose      10/17/12 10:07      
            you probably should back away from the original      Richard Erlacher      10/17/12 11:31      

Back to Subject List