Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Andy Neil
12/31/12 06:08
Read: 893 times
Basingstoke
Uk


 
#189053 - RE: single line execution in 'C' ?
Responding to: Steve M. Taylor's previous message
Steve M. Taylor said:
Is the silab IDE + Keil demo supposed to give me single line execution in 'C' ? All I see is stepping in the assembler.

The classic problem here is where the generated code doesn't line-up nicely with any 'C' source lines - which is particularly likely at higher optimisation levels.


ISTR that Keil did have a tendency to drop into assembly view if it couldn't (quite) work out the appropriate source line...


List of 10 messages in thread
TopicAuthorDate
Silabs C8051F300      Steve M. Taylor      12/26/12 14:42      
   differences I recall      Erik Malund      12/26/12 17:27      
      Settings      Steve M. Taylor      12/27/12 04:21      
         watch the peripherals      Maarten Brock      12/27/12 07:09      
            Done that      Steve M. Taylor      12/27/12 07:25      
   suggestions      Erik Malund      12/27/12 08:05      
      TF1      Steve M. Taylor      12/27/12 10:00      
         Found it.       Steve M. Taylor      12/27/12 10:29      
            yes      Erik Malund      12/27/12 11:37      
            RE: single line execution in 'C' ?      Andy Neil      12/31/12 06:08      

Back to Subject List