Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Jim Granville
01/17/13 16:02
Read: 828 times


 
#189242 - ATF16V8CZ has Pin-keeper
Responding to: Koen De Ganck's previous message
Koen De Ganck said:
I removed the GAL and the µC is running without pull-up. (I see activity on the databus )
It is pin 11 (OE) of an ATF16V8C2, but I have board with different variants.


I think you mean ATF16V8CZ, (there is no C2), and yes, that part has Pin-keepers. You hit the jackpot ;)

The Pin-keep is a snap-action light driver, that holds a pin H or L, but it does mean it can sink about 40uA, and that just trumps your 27uA PSEN.
These light-current values are going to vary quite a lot in production.

If you need the PLD, and want to avoid PCB changes, you could switch to the
ATF16V8BQL, as that does not use Pin-keep; it has Pullups only.


List of 24 messages in thread
TopicAuthorDate
Reset issue with new Atmel AT89LP51ED2      Koen De Ganck      01/16/13 02:42      
   Do never use a µC from which only a preliminary...      Kai Klaas      01/16/13 05:48      
      configuration settings      Koen De Ganck      01/16/13 05:59      
         what about negative reset?      Jan Waclawek      01/16/13 06:56      
            good idea but      Koen De Ganck      01/16/13 07:23      
   Some things to check...      Jim Granville      01/16/13 12:38      
      also try no LM810 at all      Jim Granville      01/16/13 13:02      
         reset is inverted      Koen De Ganck      01/16/13 13:30      
      no strange signals      Koen De Ganck      01/16/13 13:18      
         Extra modes ?      Jim Granville      01/16/13 16:30      
            pull-up on PSEN solves the problem      Koen De Ganck      01/17/13 03:01      
               small capacitor ?      Jim Granville      01/17/13 13:06      
                  small capacitor      Koen De Ganck      01/17/13 14:10      
   side-stepping the problem?      Jan Waclawek      01/17/13 01:34      
      SST could be an option      Koen De Ganck      01/17/13 03:08      
   final status AT89LP51ED2 reset      Koen De Ganck      01/17/13 07:43      
      Clarifies       Jim Granville      01/17/13 12:59      
         loads on PSEN      Koen De Ganck      01/17/13 14:06      
            An isolated PSEN works fine ?      Jim Granville      01/17/13 14:30      
               GAL causes problem      Koen De Ganck      01/17/13 15:41      
                  ATF16V8CZ has Pin-keeper      Jim Granville      01/17/13 16:02      
                     'Z' indeed      Koen De Ganck      01/17/13 16:35      
                        ATF16V8BQL has Icc of ~1.5mA      Jim Granville      01/17/13 16:54      
                           'BQL' version could be an option      Koen De Ganck      01/17/13 17:50      

Back to Subject List