Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Joseph Hebert
06/29/13 03:33
Read: 958 times
Okemah, Ok
United States


 
#189971 - Model #
Responding to: Jim Granville's previous message
Thanks Jim,

You nailed it. Apparently I was inattentive when I ordered. This is an AT89C51RC-24JU, NOT a ...51RC2. That's exactly why I can't get the bootloader to load. It doesn't have one.

Wonderful. Now I have to see if I can get this one off my new board without delaminating the pads.

Joe

List of 10 messages in thread
TopicAuthorDate
Atmel Bootloader/Programming FLASH      Joseph Hebert      06/28/13 17:21      
   sounds ok       Jim Granville      06/28/13 18:04      
      Model #      Joseph Hebert      06/29/13 03:33      
         Snip first ?      Jim Granville      06/29/13 23:36      
            Snipping      Joseph Hebert      07/01/13 06:35      
               Have you considered using adapters?      Richard Erlacher      07/01/13 07:40      
                  Removing ICs      Mahmood Elnasser      07/01/13 08:44      
                     solder reflow station      Jacob Boyce      07/01/13 09:07      
                        me too      Mahmood Elnasser      07/01/13 13:04      
               AT89LP51Rx2 series ?      Jim Granville      07/01/13 14:32      

Back to Subject List