Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Jim Granville
06/29/13 23:36
Read: 864 times


 
#189972 - Snip first ?
Responding to: Joseph Hebert's previous message
Joseph Hebert said:

Wonderful. Now I have to see if I can get this one off my new board without delaminating the pads.


In cases like this, where the board matters more than the part, you can snip the leads, using a lift-then-snip walk-around.



List of 10 messages in thread
TopicAuthorDate
Atmel Bootloader/Programming FLASH      Joseph Hebert      06/28/13 17:21      
   sounds ok       Jim Granville      06/28/13 18:04      
      Model #      Joseph Hebert      06/29/13 03:33      
         Snip first ?      Jim Granville      06/29/13 23:36      
            Snipping      Joseph Hebert      07/01/13 06:35      
               Have you considered using adapters?      Richard Erlacher      07/01/13 07:40      
                  Removing ICs      Mahmood Elnasser      07/01/13 08:44      
                     solder reflow station      Jacob Boyce      07/01/13 09:07      
                        me too      Mahmood Elnasser      07/01/13 13:04      
               AT89LP51Rx2 series ?      Jim Granville      07/01/13 14:32      

Back to Subject List