Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Kerim Fahme
04/03/16 01:52
Read: 895 times
Aleppo
Syria


 
#190644 - AT89LP Developer Studio
I installed and run without problem (on my old XP laptop) its version 2.3.1 (likely its last one).
After hours (exploring the menus and documents), I couldn't find the way to how to set the MCU crystal frequency.

Naturally, in this case, the debugger (via internal simulator for C51ASM or SDCC project) cannot provide the processor timing (total or relative) in cycles and/or micro-seconds.

Is it just me?

Thank you.

List of 8 messages in thread
TopicAuthorDate
AT89LP Developer Studio      Kerim Fahme      04/03/16 01:52      
   AT89LP Developer Studio reports Cycles      Jim Granville      04/04/16 22:17      
      (this and?) other chips      Erik Malund      04/05/16 08:29      
         Thank you, Erik,      Kerim Fahme      04/05/16 11:15      
         Cycle variations      Jim Granville      04/05/16 14:08      
      Thank you, Jim      Kerim Fahme      04/05/16 11:04      
         TSim51 Windows/Linux       Jim Granville      04/05/16 13:58      
            Thank you again, Jim.      Kerim Fahme      04/06/16 01:03      

Back to Subject List