Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Thread Closed: Off-topic

Oleg Sergeev
07/07/05 00:11
Read: 762 times
St. Petersburg
Russia


 
#96747 - explain
Responding to: Michael Karas's previous message
Michael,

I`m not good in analog practice, so my question:
is it correct that GND pin of LM4120 is not connected to the ground plane but tied to the anode of diode instead?

Could you explain, please,

Thanks,
Oleg




List of 16 messages in thread
TopicAuthorDate
measuring water temp inside tube      Juan Arredondo      07/06/05 12:19      
   re: measuring temp      Jacob Boyce      07/06/05 12:31      
   ir thermometers      Jez Smith      07/06/05 12:33      
      failling that .....      Jez Smith      07/06/05 12:35      
   Non-contact temperature measurement        Joseph Hebert      07/06/05 12:39      
      re:measuring temp.      Jacob Boyce      07/06/05 12:51      
      Auto Clave!      Mehdi      07/06/05 21:39      
         Auto Clave!      Mehdi      07/07/05 01:25      
   Why rubber ?      Steve M. Taylor      07/06/05 14:26      
   insulate?      Jan Waclawek      07/06/05 14:33      
   My Idea....      Michael Karas      07/06/05 23:11      
      explain      Oleg Sergeev      07/07/05 00:11      
         Current Source      Michael Karas      07/07/05 00:29      
   Is isolation necessary?      Michael Karas      07/06/05 23:54      
   Where is Juan?      Jacob Boyce      07/07/05 14:35      
      Dunno      Steve M. Taylor      07/07/05 15:07      

Back to Subject List