Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Farshid Jafari Harandi
09/07/05 14:33
Read: 706 times
Sweden
Gothenburg


 
#100774 - Price ...
Responding to: Erik Malund's previous message
As in this project the ferrite core and it's characteristics are not very important , using such an edited ferrite is not so harmfull , about the price the final Tool won't be priced more than $15 (USD).and other problem is there that probably those sensors are not available here , and if i decide to buy them overseas it would cost me much more than <$10 per unit for my low quantities.

Ferrites are very brittle, I'd not even dream about cutting one.

Sure, but i'll take care and try to use a suitable cutting tool for my purpose, some losses shouldn't be much important.

List of 7 messages in thread
TopicAuthorDate
cutting some part of ferrites !      Farshid Jafari Harandi      09/06/05 17:16      
   ferrite cores      Russell Bull      09/07/05 01:51      
      so i should use bigger EI's      Farshid Jafari Harandi      09/07/05 04:42      
         ferrites      Russell Bull      09/07/05 06:14      
            i've more than 6 AT PSU's on my hands!      Farshid Jafari Harandi      09/07/05 14:28      
   buy not build      Erik Malund      09/07/05 07:39      
      Price ...      Farshid Jafari Harandi      09/07/05 14:33      

Back to Subject List