Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Suresh R
11/04/05 23:56
Read: 1590 times
Chennai
India


 
#103309 - two layer PCB
Hello All,
In two layer micro based PCB design can i have connected the GND net to Bottom layer copper pour. But i have doubt whether i could connect the Vcc (+5VDC) to Top layer copper pour. IF i do so will it give rise to any problem.


The board also has +28VDC traces.

+5VDC drives the Micro & SSR's.
Coils use the +28VDC from the board

Suresh.

List of 16 messages in thread
TopicAuthorDate
two layer PCB      Suresh R      11/04/05 23:56      
   +5VDC also drives PhotoMOS relays      Suresh R      11/05/05 00:13      
   Solid ground plane is needed!      Kai Klaas      11/06/05 05:18      
      what i have done is      Suresh R      11/07/05 10:19      
         what you have done ...      Andy Peters      11/07/05 11:36      
            Thermal relief's      Suresh R      11/08/05 03:09      
               You need a solid ground plane      Kai Klaas      11/08/05 08:03      
                  I want the best money can buy, but do no      Erik Malund      11/08/05 08:22      
                  Thermal relief in PCB's      Suresh R      11/08/05 11:24      
                     An illustration...      Kai Klaas      11/09/05 06:26      
                        went through the design but      Suresh R      11/10/05 04:46      
                           Thermal reliefs were demonstrated      Kai Klaas      11/10/05 05:30      
                           who are you posting to????      Erik Malund      11/10/05 06:14      
               thermal reliefs only ease soldering        Sasha Jevtic      11/08/05 12:37      
                  Resistance calculation for thrmal relief      Suresh R      11/08/05 22:35      
                     you better read .....        Abhishek Singh      11/10/05 05:56      

Back to Subject List