Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Erik Malund
12/20/05 06:12
Read: 668 times
Mt Airy, Nc
USA


 
#105587 - if you refer to D4 then
Responding to: Suresh R's previous message
The o/p of 7805 reads 5VDC
But the LED connected to its o/p through a 500 ohms resistor
glows dim.

Assuming you have a constant "low" on the port pin: If you refer to D4 then a) what does that datasheet say about max sink current on the port and b) if a) is not the problem you are using an LED that either is too large or too inefficient. I drive my little "show it works" LEDs through 1k and they are not "dim"

Erik


List of 33 messages in thread
TopicAuthorDate
Add on card programming      Suresh R      12/07/05 03:11      
   please clarify      Jan Waclawek      12/07/05 03:35      
      RE: please clarify      Suresh R      12/07/05 04:35      
         (E)ISA addressing      Jan Waclawek      12/07/05 04:48      
            IOW and IOR      Suresh R      12/08/05 04:52      
               not explicitly      Jan Waclawek      12/08/05 06:02      
                  IRQ in EISA slot      Suresh R      12/09/05 01:05      
                     interrupt      Jan Waclawek      12/09/05 02:21      
                        QBASIC programming      Valentin Angelovski      12/09/05 04:53      
                           reply      Suresh R      12/10/05 04:10      
                              DIP Switch Address Setting in EISA card      Suresh R      12/12/05 03:10      
                                 DIP switches...      Valentin Angelovski      12/12/05 03:55      
                                    card design enclosed      Suresh R      12/13/05 02:10      
                                       comparator      Jan Waclawek      12/13/05 02:30      
                           QBASIC live and well.      Charles Bannister      12/12/05 11:12      
                              NT - not quite      Andy Neil      12/12/05 16:16      
                                 timing in Win?      Jan Waclawek      12/12/05 16:21      
                              QBasic Lives!!!      Valentin Angelovski      12/12/05 17:24      
   refer to 'Barry B Brey'      Abhishek Singh      12/07/05 07:39      
   EISA Bus interfacing      Valentin Angelovski      12/08/05 15:54      
      beware if (E)ISA bus books      Erik Malund      12/09/05 08:11      
   Try this?      Andy Neil      12/14/05 15:16      
      Power resistor selection      Suresh R      12/16/05 04:52      
         dont do it      Erik Malund      12/16/05 06:39      
            LM317 is an option      Abhishek Singh      12/16/05 07:46      
               Wasteful!      Andy Neil      12/16/05 09:34      
                  if op can...........      Abhishek Singh      12/17/05 07:16      
                     Power!      Andy Neil      12/17/05 08:27      
         basic Ohm's law      Andy Neil      12/16/05 09:40      
            Trouble shoot      Suresh R      12/19/05 05:13      
               heating      Terry Lingle      12/19/05 07:08      
                  Reply : Heating      Suresh R      12/20/05 04:29      
                     if you refer to D4 then      Erik Malund      12/20/05 06:12      

Back to Subject List