Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Suresh R
02/23/06 04:43
Read: 627 times
Chennai
India


 
#110574 - Maximum IOL per port pin: 10 mA ?
Responding to: Kai Klaas's previous message
Also the datasheet (in note 1) says,
Under steady state (non-transient) conditions,
IOL must be externally limited as follows:
1) Maximum IOL per port pin: 10 mA
2) Maximum IOL per 8-bit port:
Port 0: 26 mA .
Ports 1, 2, 3: 15 mA

Here i would like get cleared with point 1).
It states max IOL per port pin = 10mA, which i find is not similar to any port pin (0 ,1, 2 or 3) IOL values.
Doubt: Does that mean that p1.x could sink 10 mA when kept low.
So, i would like to know what does this IOL = 10mA signify.

Suggestions required.

suresh.

List of 19 messages in thread
TopicAuthorDate
AT89s52 Port pin clarifications:      Suresh R      02/16/06 02:14      
   nice copy, where is the question      Erik Malund      02/16/06 06:30      
   output characteristics      Jan Waclawek      02/16/06 06:53      
      most confusing post      Jez Smith      02/16/06 07:34      
   Answers      Kai Klaas      02/16/06 10:35      
      Logic 1 to 0 transition      Suresh R      02/17/06 05:01      
         You haven't read the 'bible' chapter...      Kai Klaas      02/17/06 08:38      
            no details about transition from logic 1      Suresh R      02/18/06 03:27      
               other way 'round      Jan Waclawek      02/18/06 04:21      
               There ARE!!      Kai Klaas      02/18/06 06:54      
                  pFET2      Suresh R      02/19/06 07:29      
                     Weak and very weak pull-ups      Kai Klaas      02/20/06 07:19      
      maintaining low source impedence?      Suresh R      02/20/06 03:39      
         by making thje driver a sink............      Abhishek Singh      02/21/06 10:02      
         Pull-downs create problems      Kai Klaas      02/22/06 08:00      
            Maximum IOL per port pin: 10 mA ?      Suresh R      02/23/06 04:43      
               IOL      Kai Klaas      02/23/06 06:22      
                  IOL = 10mA or 1.6mA? in port 1      Suresh R      02/23/06 22:26      
                     Depends on load      Kai Klaas      02/25/06 07:40      

Back to Subject List