Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Kai Klaas
03/02/06 11:11
Read: 401 times

#111090 - No repair possible
Responding to: Abhishek Singh's previous message
Abhishek said:
but even though i kept it tight it hardened. can you suggest what can be the emulsifier so that i can form the paste again?

If you haven't opend it, are you sure, that your vendor gave you a fresh one? Bring it back to him and tell him what you observed, then maybe he will give you a fresh one.

A hardened solder paste cannot be repaired by anything, at least to my knowledge. Datasheets I have (unfortunately only in german) tell, that there's no chance to use any solvent to get it soft again. Properties shall heavily worsen then.

Good luck,

List of 13 messages in thread
Solder wire and solder paste from EDSYN      Kai Klaas      02/28/06 07:09      
   Found this      Kai Klaas      02/28/06 07:16      
   How odd!      Joseph Hebert      02/28/06 07:38      
      Strange      Kai Klaas      02/28/06 09:05      
   part number for EDSYN solder?      Ijaz Ahmed      02/28/06 08:23      
      Thanks! I was looking for Cr88      Kai Klaas      02/28/06 08:55      
         Best of Luck dear Kai      Abhishek Singh      02/28/06 22:34      
            Thanks!      Kai Klaas      03/01/06 06:39      
   not of my choice but what is available..      Abhishek Singh      03/02/06 07:33      
      No repair possible      Kai Klaas      03/02/06 11:11      
         Stirring      Steve M. Taylor      03/02/06 11:56      
            bad news      Abhishek Singh      03/02/06 18:02      
               And..      Kai Klaas      03/02/06 18:06      

Back to Subject List