Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Michael Karas
04/19/12 20:48
Read: 461 times
Beaverton Or
USA


 
#187229 - Needing To Do Three Times Is A Kludge
Responding to: ???'s previous message
Maunik Choksi said:
I found same problem as you described here in the past.I initialsed the LCD thrice and I get success.


Needing to initialize the LCD controller three times to get it to work is an incredible kludge.

The most highly likely reason that it does not work correctly on the first initialization attempt is that that you are not meeting either the interface pulse time requirements or you are not meeting the minimum delay requirements between the initialization commands.

Michael Karas


List of 9 messages in thread
TopicAuthorDate
[project]Calculator 4x4 keypad + 2x16LCD - Result      Lukasz Stanowski      04/07/12 09:57      
   wrong approach      Erik Malund      04/07/12 14:45      
      LCD      Lukasz Stanowski      04/18/12 16:27      
         Initialise it more than one time      Maunik Choksi      04/19/12 01:38      
            Needing To Do Three Times Is A Kludge      Michael Karas      04/19/12 20:48      
               Thanks      Maunik Choksi      04/19/12 23:18      
                  Intent Applied; But Verified??        Michael Karas      04/20/12 05:34      
                     previous experiences      Erik Malund      04/20/12 06:12      
                     ' Will see it again      Maunik Choksi      04/20/12 22:22      

Back to Subject List