Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Kalpak Dabir
11/27/12 22:10
Read: 524 times
Pune
India


 
#188919 - And what is the cost of testing?
Responding to: Erik Malund's previous message
How much will the above solutions add to the cost of temperature range compliance testing?
You will have to first test the above solution before you can incorporate it in the system.
And then do the system level test.

List of 27 messages in thread
TopicAuthorDate
-40 degree Celsius operation      Raj Nambiar      11/24/12 03:45      
   Heating pads      Hal Albach      11/24/12 04:15      
   Undefined behaviour!      Andy Neil      11/24/12 04:51      
      bending it in neon      Erik Malund      11/24/12 08:31      
         That means that you're on your own ... no support       Richard Erlacher      11/24/12 08:53      
   Why?      Kai Klaas      11/24/12 08:52      
      Not in Dubai      Raj Nambiar      11/26/12 07:12      
         nobody has been that stupid      Erik Malund      11/26/12 07:47      
         So many pitfalls...        Oliver Sedlacek      11/26/12 10:18      
            testing      Erik Malund      11/26/12 12:49      
               And what is the cost of testing?      Kalpak Dabir      11/27/12 22:10      
                  the cost of testing      Andy Neil      11/29/12 00:54      
                     it's not just pass/fail ...        Richard Erlacher      11/30/12 09:47      
                        Tell me about it!      Andy Neil      11/30/12 11:24      
                        Why?      Erik Malund      11/30/12 14:13      
                           Why??? It's to protect your own gluteus maximus      Richard Erlacher      11/30/12 15:28      
         what would happen       Andy Neil      11/26/12 23:42      
   Heaters/controllers      Joseph Hebert      11/24/12 20:31      
   Low temp components      Oliver Sedlacek      11/26/12 02:45      
      Potting wont help       Andy Neil      11/26/12 23:45      
         it's probably less costly to heat a small enclosure      Richard Erlacher      11/27/12 00:08      
            at very cold start...      Stefan KAnev      11/27/12 06:18      
               Yes it can ...      Richard Erlacher      11/27/12 10:16      
   it's not that simple ...       Richard Erlacher      11/27/12 00:13      
      heater      Erik Malund      11/27/12 07:25      
         With an NTC resistor driving the base?      Oliver Sedlacek      11/27/12 08:35      
            It's very simple...      Kai Klaas      11/28/12 05:37      

Back to Subject List