Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Kai Klaas
01/10/13 05:14
Read: 639 times
Germany


 
#189119 - And...
Responding to: Oliver Sedlacek's previous message
...by using good and low ohmic cable, AWG20 instead of AWG24.

Another "trick" is to increase the termination resistances a bit. But then you should drastically slow down the data rate and use slew rate limited drivers.

Kai Klaas

List of 10 messages in thread
TopicAuthorDate
RS485 Communication Line      Satish S Munot      01/08/13 05:11      
   One eighth load receivers      Oliver Sedlacek      01/08/13 07:07      
   Length?      Satish S Munot      01/08/13 07:40      
      current loop      Maarten Brock      01/09/13 16:38      
         Current loop       Satish S Munot      01/09/13 23:27      
            Try googling "current loop"       Richard Erlacher      01/10/13 00:24      
            in series      Maarten Brock      01/10/13 03:07      
      That works      Oliver Sedlacek      01/10/13 01:52      
         And...      Kai Klaas      01/10/13 05:14      
   Current Loop      Satish S Munot      01/10/13 06:23      

Back to Subject List