Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Kartik Sulakhsan
01/17/13 18:44
Read: 687 times
Hyderabad
India


 
#189246 - not using eval
Responding to: Erik Malund's previous message
I am using SDP-UNIV-44TQ universal adapter for Labtool-48uxp/848xp series
programmer.

1.Not getting any errors/warnings in keil and hex file creation is
successful in keil.

2.erase,load,program successfully in labtool GUI but the device is not
functioning/configuring .

3.observations when assembled in my board:
VDD:3.3V
VSS:0V
RESETN:3.3V
REMAINING PINS:0.7V to 1.1V.
but i am expecting high logic(3.3V) on some test points(port P5) of my code.

4.included header file in keil:reg952.h and startup code:START954.A51.
(UCFG1,UCFG2,boot vector,status bytes in START954.A51:all default, I have
not edited the START954.A51).

5.Am I missing any thing?/need to change configuration settings in
START954.A51 or LABTOOL GUI before programming?

List of 11 messages in thread
TopicAuthorDate
not getting response from p89lpc954      Kartik Sulakhsan      01/17/13 09:02      
   did you do it as a project?      Erik Malund      01/17/13 09:39      
      yes      Kartik Sulakhsan      01/17/13 09:51      
         are you using the eval?      Erik Malund      01/17/13 13:03      
            not using eval      Kartik Sulakhsan      01/17/13 18:44      
               what is      Erik Malund      01/17/13 21:01      
                  repeat - what is      Erik Malund      01/19/13 10:37      
               is the oscillator running?      Erik Malund      01/17/13 21:18      
      questions      Erik Malund      01/19/13 10:36      
   What at the others in your class doing ?      Jim Granville      01/17/13 22:07      
      7.373MHZ internal      Kartik Sulakhsan      01/19/13 09:32      

Back to Subject List