Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
James Brzycki
02/25/13 06:33
Modified:
  02/25/13 07:01

Read: 865 times
Hammond
Us


 
#189468 - comments
Responding to: Hal Albach's previous message
Ok, thank you for that, and that makes sense so theres not so much there, and I do understand the LM34, it outputs a analog signal that represents 10mV/F and I believe I have the LM34C. And as for the output of the adc its a binary value correct, because if hooked up to led's it shows a binary code of 01001110 which is 78 which is rounded up from the measuered from volt meter from sensor 77.8 degrees. Also in the block DATA_DISPLAY where I'm guessing at what goes there, Im thinking it should be 50H since thats where the ascii_rslt is saved am I reading that right?

List of 22 messages in thread
TopicAuthorDate
How to display data from a ADC0808 to a LCD      James Brzycki      02/24/13 09:46      
   Comments, please      Hal Albach      02/24/13 17:25      
      Comments      James Brzycki      02/24/13 17:56      
         Code Fragments      Hal Albach      02/24/13 21:01      
            Commenst added, reply to hal      James Brzycki      02/24/13 21:11      
               comments      Hal Albach      02/24/13 22:46      
                  comments      James Brzycki      02/25/13 06:33      
                     Program flow      Hal Albach      02/25/13 11:40      
                        comments      James Brzycki      02/25/13 21:45      
                           Clarification & Suggestions      Hal Albach      02/26/13 07:44      
                              GREAT HELP      James Brzycki      02/26/13 11:39      
                                 Data Display loop      Hal Albach      02/26/13 12:24      
                                    Worked sorta      James Brzycki      02/27/13 06:57      
                                       The output      Hal Albach      02/27/13 15:29      
                                          I looked at it wrong      James Brzycki      02/27/13 17:19      
                                             Works      James Brzycki      02/27/13 20:35      
                                                Great news!      Hal Albach      02/28/13 07:05      
                                                   Thank you      James Brzycki      02/28/13 07:15      
                                                      You're Welcome      Hal Albach      02/28/13 08:33      
                                                      A couple of questions      Hal Albach      02/28/13 11:06      
                                                         Answers and questions      James Brzycki      02/28/13 11:54      
                                                            Thanks      Hal Albach      02/28/13 12:36      

Back to Subject List