Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Mahmood Elnasser
10/09/13 05:52
Read: 1111 times
Sacramento
USA


 
#190044 - pin layout
Responding to: Michael Karas's previous message
Michael Karas said:
Mahmood,
The two SIL cables works OK when the pin assignments of the DIL end are flexible. When the DIL end is already assigned such that pin 1 goes to pin 1, 8 to 8, 9 to 9 and 16 to 16 on the ribbon cable then the SIL cables are not a good choice.

You can change the pin assignment on the SIL connector easily by pulling out the pins and reassigning them to your requirements. been there done that plenty of times.
Mahmood

List of 13 messages in thread
TopicAuthorDate
LCD Adapter Assembly / Cable      Michael Karas      10/08/13 15:03      
   headers and plugs      Joseph Hebert      10/08/13 17:57      
      Grunch On Ribbon Connectors      Michael Karas      10/08/13 22:26      
         Solution      Joseph Hebert      10/09/13 10:01      
            Point Taken      Michael Karas      10/09/13 11:18      
   two solutions      Mahmood Elnasser      10/09/13 03:09      
      Almost      Michael Karas      10/09/13 05:37      
         pin layout      Mahmood Elnasser      10/09/13 05:52      
            Re-Poking Pins      Michael Karas      10/09/13 08:17      
   I've seen this, but is it "standard"?      Richard Erlacher      10/14/13 09:21      
      Standard???      Michael Karas      10/15/13 06:33      
         Doubtful if there is any standard what so ever.       Andy Neil      10/18/13 11:35      
         Standard is probably a poor choice of terms ...       Richard Erlacher      10/21/13 12:58      

Back to Subject List