Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Michael Karas
10/09/13 08:17
Read: 903 times
Beaverton Or
USA


 
#190045 - Re-Poking Pins
Responding to: Mahmood Elnasser's previous message
Good Idea ! ! !

I just purchased a bundle of 1x8 cables on eBay and then also purchased some 2x8 connector ends on eBay. These seem to be commonly referred to as "Dupont" wires/cables that are aimed at the Arduino marketplace. I'll remove all wires from one end of a pair of the 1x8's and re-insert them as appropriate into the 2x8 connector.

Nice solution, very low cost and ultimately superior to the direct soldered approach on the LCD module.

Michael Karas


List of 13 messages in thread
TopicAuthorDate
LCD Adapter Assembly / Cable      Michael Karas      10/08/13 15:03      
   headers and plugs      Joseph Hebert      10/08/13 17:57      
      Grunch On Ribbon Connectors      Michael Karas      10/08/13 22:26      
         Solution      Joseph Hebert      10/09/13 10:01      
            Point Taken      Michael Karas      10/09/13 11:18      
   two solutions      Mahmood Elnasser      10/09/13 03:09      
      Almost      Michael Karas      10/09/13 05:37      
         pin layout      Mahmood Elnasser      10/09/13 05:52      
            Re-Poking Pins      Michael Karas      10/09/13 08:17      
   I've seen this, but is it "standard"?      Richard Erlacher      10/14/13 09:21      
      Standard???      Michael Karas      10/15/13 06:33      
         Doubtful if there is any standard what so ever.       Andy Neil      10/18/13 11:35      
         Standard is probably a poor choice of terms ...       Richard Erlacher      10/21/13 12:58      

Back to Subject List