Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
Joseph Hebert
10/09/13 10:01
Read: 1044 times
Okemah, Ok
United States


 
#190046 - Solution
Responding to: Michael Karas's previous message
Michael,

Obviously I don't know the details of your time frame requirements, or the quantity you'll be dealing with, but I would be leary of such stop-gap solutions for anything on its way to production. The real solution here looks like revisiting the design with whomever did the PWB layout and have them correct one end or the other to make them both match. Of course, since I don't know your anticipated production quantity, it may be more economical to just design an adapter board, but be careful about adding impedance discontinuities.

Good luck,

Joe

List of 13 messages in thread
TopicAuthorDate
LCD Adapter Assembly / Cable      Michael Karas      10/08/13 15:03      
   headers and plugs      Joseph Hebert      10/08/13 17:57      
      Grunch On Ribbon Connectors      Michael Karas      10/08/13 22:26      
         Solution      Joseph Hebert      10/09/13 10:01      
            Point Taken      Michael Karas      10/09/13 11:18      
   two solutions      Mahmood Elnasser      10/09/13 03:09      
      Almost      Michael Karas      10/09/13 05:37      
         pin layout      Mahmood Elnasser      10/09/13 05:52      
            Re-Poking Pins      Michael Karas      10/09/13 08:17      
   I've seen this, but is it "standard"?      Richard Erlacher      10/14/13 09:21      
      Standard???      Michael Karas      10/15/13 06:33      
         Doubtful if there is any standard what so ever.       Andy Neil      10/18/13 11:35      
         Standard is probably a poor choice of terms ...       Richard Erlacher      10/21/13 12:58      

Back to Subject List