Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Grant Beattie
12/11/17 19:40
Read: 68 times
San Juan Capistrano, Ca
USA


 
#190827 - Banked SRAM
Responding to: Richard Erlacher's previous message
Thanks Richard. I will look into some of the things you mentioned. I'm sure my original post lacked clarity. This is an old school expanded bus system with standard 6264 type SRAM that is non-volatile via a small coin cell battery. The only thing I can do is remove the (socketed) SRAM to install a larger SRAM (board) that will be banked in at the existing memory map. The banks will be controlled by physical SPST or SPDT type switches. That's the whole scope.

So my concern was with the address line connected to the bank select switch. When the unit is powered off, almost everything is powered down except for the SRAM and a small amount of CMOS logic connected to it (for reset management etc making sure there are no spurious writes during power on/off). Really it's just what to do with the high order address-line also known as bank-select.



List of 4 messages in thread
TopicAuthorDate
Old School SRAM Memory Expansion      Grant Beattie      12/08/17 12:51      
   Old School SRAM Memory Expansion      Grant Beattie      12/08/17 19:39      
   maybe this isn't the easiest way ...       Richard Erlacher      12/11/17 12:26      
      Banked SRAM      Grant Beattie      12/11/17 19:40      

Back to Subject List